TECHNICAL SPECIFICATION

TERMARUST 2301
SPLASH ZONE COATING

DESCRIPTION
Termarust 2301 is a single component air dry high solids topcoat specifically designed and formulated as a splash zone coating for use in moderate to severe industrial exposures, where dirt pick-up and heavy traffic are a concern.

USES
Termarust 2301 may be used to topcoat Termarust 2100 Primer/Topcoat, Termarust 2303 and Termarust 2304. Termarust 2301 may be used as a topcoat for structural steel, bridges, tanks, piping, towers, equipment and other similar surfaces.

COLOR

Standard colors (Custom colors on request)

SHEEN

Semi Gloss

COMPATIBLE SYSTEMS

Termarust 2100 Self Priming Topcoat
Termarust 2302 Zinc Primer
Termarust 2303 White Midcoat
Termarust 2304 Red Oxide Primer

GENERIC TYPE

Modified Silicone

SOLVENT

Aliphatic Hydrocarbons

SOLIDS BY WEIGHT

63.5% ± 2%

SOLIDS BY VOLUME
52.1% ± 2%

V.O.C. (Volatile Organic Compound)
3.2 Lbs. / U.S. Gal

RECOMMENDED DFT (DRY FILM THICKNESS)
1.5 - 2.5 mils DFT

SPREADING RATE
Theoretical coverage at 2 mils DFT 401 square feet / U.S. Gal DFT

DRY TIME @ 25°C - 50% R.H. (relative humidity)
TACK FREE:3 hours
TO HANDLE:6 hours
HARD:7 hours
RECOAT:24 hours

VISCOSITY
112 Kreb Units

SURFACE PREPARATION
Previously primed or coated contaminant free surfaces.

APPLICATION
The Modified Silicone should be applied only when the air and product temperature is between 45° F to 90° F and the surface has been properly prepared. The surface temperature should not exceed 125°F.

THINNING
Brush/Roller:
If desired reduce maximum of 15% by volume with Termarust thinner TR 01
Airless:
Reduce up to 45 % by volume with Termarust thinner TR 01
Conventional Spray:
Reduce up to 45 % by volume with Termarust thinner TR 01
Clean Up:
Use Termarust thinner TR 01

SHELF LIFE
24 months in original unopened container when stored in a protected area where the temperature is between 5°C to 30°C (41°F to 86°F).

SAFETY INFORMATION
Treat as flammable liquid - Flash point 42°C (108°F). Keep away from heat, open flame and sparks. Use with adequate ventilation. Avoid contact with skin and eyes. Avoid prolonged breathing of vapor. Read label instruction carefully and refer to Material Safety Data Sheet supplied. This product is for industrial use only.

Note:
The technical data given herein has been compiled for your help and guidance and is based upon our experience and knowledge. It is subject to modification from time to time in the light of experience and our policy of continuous product development. Persons using this product must first satisfy themselves as to its suitability for the intended purpose. Please contact your sales representative for complete recommendations.