TECHNICAL SPECIFICATION

TERMARUST 2302
LOW HAPS ZINC RICH PRIMER

DESCRIPTION
A metallic zinc primer which inhibits rust on ferrous metal by cathodic reaction, and functions as a cold galvanizing on new steel.

USES
Termarust Zinc Rich Primer through conventional painting methods provides a galvanized surface on complex fabrication made from steel and on structural steel surfaces such as transmissions towers.

COLOR
Grey

SHEEN
Flat

COMPATIBLE SYSTEMS
Long oil alkyds primers (2303 - 2304)

RESIN TYPE
Modified Alkyd

SOLVENT
Aliphatic Hydrocarbon

SOLIDS BY WEIGHT
88% ± 1%

SOLIDS BY VOLUME
51% ± 1%

V.O.C. (VOLATILE ORGANIC COMPOUND)
325 grams per liter

RECOMMENDED DFT (DRY FILM THICKNESS)
3.5 - 6.0 Mils (87.5 - 150 microns)

SPREADING RATE
3 - 6 square meter per liter ----- 32 - 64 square feet per liter

DRY TIME @ 25C - 50°% R.H.
TOUCH: 45 minutes
TACK FREE: 1 hour
HARD: 24 hours
RECOAT: Minimum: 4 hours

VISCOSITY
90 - 100 Kreb Units

SURFACE PREPARATION
All grease, oil, grime, loose rust and other contaminants must be removed from the surface using solvent, commercial or other suitable cleaning method. Sand blast to SSPC-SP5 is desirable, but if not feasible then degrease to SSPC-SP1 followed by thorough hand tool cleaning to SSPC-SP2 or power tool cleaning to SSPC-SP3.

APPLICATION
The primer should be applied only when the air, surface and product temperature is between 10°C to 30°C (50°F to 86°F) and the surface has been properly prepared.

THINNING
BRUSH OR ROLLER: No reduction is required.
CONVENTIONAL SPRAY: Reduce up to 10% by volume using thinner TR 04.
CLEAN UP: Use thinner TR 04
NOTE: Equipment should be cleaned thoroughly immediately after use.

PERFORMANCE RESISTANCE TO
ACIDS: poor
SOLVENTS: fair - good
ALKALIS: poor
WATER HUMIDITY: excellent
SALTS: fair
DRY HEAT: 120 °F

WEATHERABILITY
When suitably topcoated, the primer-finish system provides excellent durability and corrosion resistance. This system is NOT for continuous water immersion.

SHELF LIFE
12 months in original unopened container when stored in a protected area where the temperature is between 5°C to 30°C (41°F to 86°F).

SAFETY INFORMATION
Treat as flammable liquid - Flash point 42°C (108°F). Keep away from heat, open flame and sparks. Use with adequate ventilation. Avoid contact with skin and eyes. Avoid prolonged breathing of vapor. Read label instruction carefully and refer to Material Safety Data Sheet supplied.
This product is for industrial use only and is not intended for use in or around a household or dwelling.

NOTE
The technical data given herein has been compiled for your help and guidance and is based upon our experience and knowledge. It is subject to modification from time to time in the light of experience and our policy of continuous product development. Persons using this product must first satisfy themselves as to its suitability for the intended purpose. Please contact your sales representative for complete recommendations.